KellyCorey
Member
Hello,
I am at a deadend using Stratix 5700 to connect two subnets together. Needing some fresh eyes.
Basically,
I have 1 PLC (IP address is 192.168.1.1), default gateway 192.168.1.99. Stratix switch IP is 192.168.1.10. subnet 255.255.255.0
On the public network side, I have a catalyst switch at 192.168.41.1, subnet 255.255.255.0. The translated address for the PLC on the "41" subnet is 192.168.41.101.
The VLAN is setup as default from the factory. I did the express setup to fill in the IP address for the switch, the gateway is set at 192.168.1.99. Stratix switch 192.168.1.10. I did not configure any ports, smart ports or any other configuration. I then configured the NAT.
Private to Public - 192.168.1.1 to 192.168.41.101
Gateway transaltion - 192.168.41.1 to 192.168.1.99
I did not configure any Public to Private.
The issue is I can not ping the catalyst switch from inside the NAT. From outside the NAT i cannot connect to the PLC.
Is there something else I need to configured? I saw a note somewhere about VLAN trunking and smart ports configuration , auto negotiation. Where do i change VLAN trunking or smart ports (automation setting?). I followed the NAT quickstart and it did not mention any of these other settings.
Please advise.
TIA
I am at a deadend using Stratix 5700 to connect two subnets together. Needing some fresh eyes.
Basically,
I have 1 PLC (IP address is 192.168.1.1), default gateway 192.168.1.99. Stratix switch IP is 192.168.1.10. subnet 255.255.255.0
On the public network side, I have a catalyst switch at 192.168.41.1, subnet 255.255.255.0. The translated address for the PLC on the "41" subnet is 192.168.41.101.
The VLAN is setup as default from the factory. I did the express setup to fill in the IP address for the switch, the gateway is set at 192.168.1.99. Stratix switch 192.168.1.10. I did not configure any ports, smart ports or any other configuration. I then configured the NAT.
Private to Public - 192.168.1.1 to 192.168.41.101
Gateway transaltion - 192.168.41.1 to 192.168.1.99
I did not configure any Public to Private.
The issue is I can not ping the catalyst switch from inside the NAT. From outside the NAT i cannot connect to the PLC.
Is there something else I need to configured? I saw a note somewhere about VLAN trunking and smart ports configuration , auto negotiation. Where do i change VLAN trunking or smart ports (automation setting?). I followed the NAT quickstart and it did not mention any of these other settings.
Please advise.
TIA