Sysmac studio- Axis Error Troubleshooting

noorloai

Member
N
Join Date
Jun 2015
Location
ontario
Posts
25
Hi,

I have the following error keep showing up as showing in the attachment.

how can i get rid of this fault? any suggestion?

the wiring connection all right and connected properly

Thanks,

Noor

XPR6 ERROR Detection.jpg
 

Similar Topics

M
Sysmac Studio - Axis movement
Hi everyone, I have a question to ask. I need to move two axis (R88D-1SN_-ECT 1S ) for two belt conveyors. I have read the reference manuals and I...
Replies
0
Views
1,101
marvis
M
M
Command over Ethernet/IP (Sysmac Studio and Automation direct GS20)
Hi, I have been trying to run drive via Sysmac studio. I can ping the drive. I can see the logic bits going on/off as per command. But, drive is...
2
Replies
21
Views
594
tarik1978
T
R
Progstop and progstart in sysmac studio
Good morning to everyone on the forum and happy new year. I'm trying to use the following functions in sysmac studio, because I need to enable one...
Replies
1
Views
343
IO_Rack
IO_Rack
R
Function Sin,Cos in the sysmac studio
Good morning everyone, I'm having difficulty using the "sin" and "cos" functions in sysmac, in particular the results of the functions are not...
2
Replies
15
Views
1,184
Ricky87
R
M
Omron Sysmac Studio NX Place variables in structure
Hi everyone, I am trying to program a function block to copy the variables obtain from Ethercat into a structure on a NX1P2. Since I cannot...
Replies
1
Views
1,138
MITch1978
M
Back
Top Bottom