Hello all
To be honest I’m fairly new to the PLC world and even newer to HMIs But here is my dilemma at the moment.
I need to connect a TI 545 plc to an op177b HMI. I must build the HMI program using winccflex 2008. I’m not sure what kind of cable interface I need to use or if there are any special settings I need to set up for the PLC.
Any type of interface can be used (I must build the cable). Ethernet is also an option. Any suggestions or help would be greatly appreciated.
To be honest I’m fairly new to the PLC world and even newer to HMIs But here is my dilemma at the moment.
I need to connect a TI 545 plc to an op177b HMI. I must build the HMI program using winccflex 2008. I’m not sure what kind of cable interface I need to use or if there are any special settings I need to set up for the PLC.
Any type of interface can be used (I must build the cable). Ethernet is also an option. Any suggestions or help would be greatly appreciated.