Patrick
Lifetime Supporting Member
Ok. A long time ago I had a similar problem that drove me up the wall. The answer was right in front of me, but I couldn’t see it. The problem was programming my first DH+ message. I just new I had to have a command at the other end. Yes I read several times that the address had to be available. But I just couldn’t see it tell someone call my attention to it. Now I think I have the same problem.
Trying to program a 1761-NET-ENI. Let me back up. A new control cabinet came in to replace an out dated cabinet. It has a MicroLogix 1500 a NET-ENI and a panelview plus 600. The program for the MicroLogix has no documentation. The panelview plus program is a mer. not APA. I have never programmed a NET-ENI. And this is the second panelview plus that I have seen, and the first I have program.
I have the ENI/ENIW Utility. I can change the Ethernet address. How do I set the RS232 address? I see all kinds of examples in the utility manual. But I an not sending any messages.
It is late. I’m tired and confused. I hope it is something as simple as the DH+ problem was.
Trying to program a 1761-NET-ENI. Let me back up. A new control cabinet came in to replace an out dated cabinet. It has a MicroLogix 1500 a NET-ENI and a panelview plus 600. The program for the MicroLogix has no documentation. The panelview plus program is a mer. not APA. I have never programmed a NET-ENI. And this is the second panelview plus that I have seen, and the first I have program.
I have the ENI/ENIW Utility. I can change the Ethernet address. How do I set the RS232 address? I see all kinds of examples in the utility manual. But I an not sending any messages.
It is late. I’m tired and confused. I hope it is something as simple as the DH+ problem was.