I have an Ultra3000 Servo Drive (2098-DSD-HV030) that is giving me an E41 error code. The manual says that this is a "460V Shunt Protection Fault".
I'm using the Internal Shunt, and the correct jumper is present. I've checked to make sure that the motor is not being manually turned (one of the possibilities given by the manual), and it isn't.
I'm looking through the manual and can't seem to find any info on whether or not there is an internal fuse on their shunt resistor circuit that can be replaced. I tried calling tech support, but my contract only covers weekdays.
The drive powers up correctly, the network status LED turns on solid, and the module status LED flashes (Waiting for enable input). When given the Enable Input, the drive reads E41 for about 10 seconds or so, then returns to the Module Status LED Flashing, and won't respond to the enable input until the power is cycled again.
I'd really hate for a machine to be down all weekend just because a simple fuse on the inside of the drive may need replacing.
Any info or advice will be appreciated
I'm using the Internal Shunt, and the correct jumper is present. I've checked to make sure that the motor is not being manually turned (one of the possibilities given by the manual), and it isn't.
I'm looking through the manual and can't seem to find any info on whether or not there is an internal fuse on their shunt resistor circuit that can be replaced. I tried calling tech support, but my contract only covers weekdays.
The drive powers up correctly, the network status LED turns on solid, and the module status LED flashes (Waiting for enable input). When given the Enable Input, the drive reads E41 for about 10 seconds or so, then returns to the Module Status LED Flashing, and won't respond to the enable input until the power is cycled again.
I'd really hate for a machine to be down all weekend just because a simple fuse on the inside of the drive may need replacing.
Any info or advice will be appreciated