Hi Folks,
I have a ladder that includes an inductive sensor used to sense rotation at the idler end of a conveyor belt.
I'm using a Micro 820 and Connected Components Workbench. In order to test and simulate the pulsed input I have set the interval low (2 seconds) and manually toggle a switch. This has limited use
Is there any way to use the system clock to simulate a pulsed input?
Thanks
Mongoid
I have a ladder that includes an inductive sensor used to sense rotation at the idler end of a conveyor belt.
I'm using a Micro 820 and Connected Components Workbench. In order to test and simulate the pulsed input I have set the interval low (2 seconds) and manually toggle a switch. This has limited use
Is there any way to use the system clock to simulate a pulsed input?
Thanks
Mongoid