Using Vertical Shorts (branch) in Proworx32

Dryhops

Member
D
Join Date
Jan 2018
Location
California
Posts
90
I'm trying to use proworx32 for the first time and can't seem to insert a vertical short between blocks. When using the [| Short] button from the instructions toolbar, I simply get a message "Instruction not valid for this project".

While the error message is quite clear, there are plenty of vertical shorts throughout the project, as you can see in the screenshot I've attached.

Do these need to be enabled for editing somewhere?

Capture.PNG
 
Last edited:

Similar Topics

S
control of a vertical gantry using s7-200 and a stepper motor control board
Hello to all. I need some help in controlling a vertical gantry using a s7-200 with only I/O digital ports and a ST400NT stepper motor control...
Replies
0
Views
5,323
sala
S
W
Reasons for using Tc2_NcFifoAxes?
Hi I'm very new to PLC programming and I'm trying to find out if this library (Tc2_NcFifoAxes) is necessary for our task In our case we need to...
Replies
0
Views
38
wopadidoo123
W
A
ATS using a PLC
I have a project to automate four generator sets. The system will monitor and store the load demand of the factory. Once there's Power outage, the...
Replies
0
Views
89
Alibaba07
A
T
Using Patch Panels in Control Panels
Adding ethernet equipment to an existing panel that has none. We have some solid ethernet cables coming from other remote cabinets that I plan to...
Replies
3
Views
143
nicherbert
N
K
RS485 Modbus RTU using PC com port in Twincat 3 issues
I'm trying to control a device via MODBUS RTU and the ModbusRtuMasterV2_PcCOM in Twincat 3. I've configured a device with the right com port and...
Replies
7
Views
265
Jkoso
J
Back
Top Bottom