Dear Folks,
I have recently joint a new company, my first task is to prepare a new standbys server that have our main WinCC project.
The WinCC of the old server is consisting of the following:
- One S7-400 CPU connected as ISO Industrial Ethernet
- Six S7-300 CPU's connected as TCP/IP
- Each of the six S7-300 is having it's own HMI panel(Panels type are siemens Touch panels)
- The WinCC Runtime is able to access the remote HMI panels(Touch Panels) to display & control their different screens on the WinCC Project.
Below is what I have done:
- I was able to configer the new server.
- I Installed the WinCC to the new server
- I was able to get all PLC's communicationg to the WinCC Project.
I was NOT able to get the WinCC runtime to access the remote panels(Touch Panels) to be able to display their screens on the WinCC.
I would appreciate if you suggest to me what to check to get the problem fixed.
Best regards
Hagos
I have recently joint a new company, my first task is to prepare a new standbys server that have our main WinCC project.
The WinCC of the old server is consisting of the following:
- One S7-400 CPU connected as ISO Industrial Ethernet
- Six S7-300 CPU's connected as TCP/IP
- Each of the six S7-300 is having it's own HMI panel(Panels type are siemens Touch panels)
- The WinCC Runtime is able to access the remote HMI panels(Touch Panels) to display & control their different screens on the WinCC Project.
Below is what I have done:
- I was able to configer the new server.
- I Installed the WinCC to the new server
- I was able to get all PLC's communicationg to the WinCC Project.
I was NOT able to get the WinCC runtime to access the remote panels(Touch Panels) to be able to display their screens on the WinCC.
I would appreciate if you suggest to me what to check to get the problem fixed.
Best regards
Hagos