Yaskawa Line shaft A1000

pasbra

Member
P
Join Date
Oct 2021
Location
Québec
Posts
31
Hi,

I want to do an electronic line Shaft with Yaskawa A1000. I think a must update firmware.

Do is a user that have a firmware for this?

I need also cable UWR01076. Do you have a pinout for this cable?

If you have a experience with this, give me your experience... :)

Thank you!

Pascal
 

Similar Topics

S
Yaskawa Limit command
Dear forum members, By reffering to the blue labelled command on the attached file, Could you tell me what PLC register that is being limited by...
Replies
0
Views
82
simatixplc
S
B
Extract time from Yaskawa registers in Studio 5000
What is the best way to extract the hour and minute from the register that comes from Yaskawa VFD. In studio 5000 I have a register saved as INT...
Replies
3
Views
161
Bart_PSI
B
V
Yaskawa GL60s PLC
Hi sir I has a equipment use Yaskawa GL60s PLC via P150 developer,we want to upgreat the system to New,but we have some problems For example: On...
Replies
0
Views
162
van83619
V
E
YASKAWA Control
Hi Everybody, this may be one for you motion control guys. We have been tasked with interfacing some Yaskawa drives into a project where the...
Replies
0
Views
287
exiled
E
N
Yaskawa GA800 VFD bUS [Option Communication Error]
Hello, We have several Yaskawa GA800's installed in our plant. They are all controlled via Ethernet and they work fine. However, they all get...
Replies
0
Views
506
NGCPLC
N
Back
Top Bottom