jwyatt8171
Member
I have a few quickpanels on some older equipment. Connected to GE Fanuc 90-30 PLCs.
I have went through 4 of the MI-CAB-C49 cables over the past few years. Im wondering why. It seems every time I go to use it the cable is toast again. I am the only user that uses them.
I power off the HMI before connected or disconnecting(im not 100% sure on the disconnect, but will from not on)
When call for a download, it sees the comm port, and tells the screen to go dark. Then prompts me to remove power from the HMI. Then after I do that it immediately tells me to power it back up. Then when power is applied it says waiting to go online. It times out and starts this again, asking me to power it off.......
I have seen this previously, and a new cable has fixed the issue. What could i be doing that is causing this problem?
Any foresight is appreciated.
I have went through 4 of the MI-CAB-C49 cables over the past few years. Im wondering why. It seems every time I go to use it the cable is toast again. I am the only user that uses them.
I power off the HMI before connected or disconnecting(im not 100% sure on the disconnect, but will from not on)
When call for a download, it sees the comm port, and tells the screen to go dark. Then prompts me to remove power from the HMI. Then after I do that it immediately tells me to power it back up. Then when power is applied it says waiting to go online. It times out and starts this again, asking me to power it off.......
I have seen this previously, and a new cable has fixed the issue. What could i be doing that is causing this problem?
Any foresight is appreciated.