collinsd70
Member
Hi All.
I am trying to commission a Powerflex 525 Drive but currently only have access to +24VDC, I simply want to assign Ethernet/IP Address, get comms working, firmware updates etc etc.
Looking through the documentation- It would appear that the control voltage is generated internally through the 3-phase (ie I cannot power the control circuit seperatley).
Can anyone confirm this?, I have looked through the manual and control wiring schematic and there does not appear to require any power input at the control circuit?
Regards
Daniel
I am trying to commission a Powerflex 525 Drive but currently only have access to +24VDC, I simply want to assign Ethernet/IP Address, get comms working, firmware updates etc etc.
Looking through the documentation- It would appear that the control voltage is generated internally through the 3-phase (ie I cannot power the control circuit seperatley).
Can anyone confirm this?, I have looked through the manual and control wiring schematic and there does not appear to require any power input at the control circuit?
Regards
Daniel