I a new at this and also new as a programmer. I have a Devicenet 1769 and the logic status indicator light is out. I've done some research and I've found that logics is disabled. It also says I need byte 2, bit 5 as a 1 to enable it but it's in a read only file. Any ideas on where to start looking to correct this problem.
micrologix1500 to Devicenet 1769-sdn
- Thread starter Goodygolf
- Start date
Similar Topics
Hi,
I have AB devicenet card 1769-SDN with Micrologix1500. I am using this as a master. I would like to know what are the hard requirements to...
Hello everyone
I have a micrologix1500 connected with RS232 to my computer, and connected to the 1761-net-dni with a series connexion from the...
Hello Everyone,
Let me start out by saying I am definitely not a pro by any stretch of the imagination. What I have is a Micro850 that is on the...
Okay so I just went into my ML1500 and mistakenly changed a comm setting for channel 0 or 1 channel config section of the programming software...
Hi,
I have a Micrologix PLC 1500 on which channel 0 is free. I need to take this PLC in scada via ethernet module any one can suggest a suitable...
