Hi
I'm using a HSC interrupt so that when the counter reference value is reached my interrupt block runs and sets an output then writes a new reference value to the high speed counter, when the new value is reached it runs again and switches the output off and resets my reference value to start the cycle again. My question is can I reliably use a timer in this interrupt OB. I'm not sure if I can as the block only runs once everyone the RV is reached.
Any info would be appreciated.
I'm using a HSC interrupt so that when the counter reference value is reached my interrupt block runs and sets an output then writes a new reference value to the high speed counter, when the new value is reached it runs again and switches the output off and resets my reference value to start the cycle again. My question is can I reliably use a timer in this interrupt OB. I'm not sure if I can as the block only runs once everyone the RV is reached.
Any info would be appreciated.