CX-one Step programming reset

Hi,

I am programming a blow moulding machine with 2 stations. So far I have the sequence done with function STEP ( and SNXT). How can I jump automatically to Step 1 when I press the "Cycle Stop" button.

At the very moment when I press cycle stop the current marker in the sequence stays. So when I go to Basic Position and press cycle START all gets mixed up because the cycle is not at Step 1

Copied from an example I use the work marker for each step:

Step 1 W100.01
Step 2 W100.02
aso.

Function
RSETA [W100.00 1 15]

doesnt work. Error message "Operand out of range."

Thanks for help.

Andy

http://www.omron-ap.com/service_support/FAQ/FAQ01011/index.asp

Add another rung that when cycle stop is executed then the next step will be the starting step that you want.

Regards,