smith31
Member
I cant seem to get RSLinx to autoconfigure the setup for my PV300 Panel. It keeps asking me to "Check all cables and switch settings". Which switches is it talking about?
Panelview 300 & RSLinx Lite
- Thread starter smith31
- Start date
bernie_carlton
Lifetime Supporting Member + Moderator
I think this is a generic warning trying to cover all possibilities including some older panels which used internal switches to configure some parameters. I would mainly check that you have the correct cable given the specific model of PV 300 that you may have.
Bregage
Member
Are you using a null modem connector on your cable? I think you probably need one to connect.
Pat
Pat
Similar Topics
Trying to make a change on a panelview 300 #2711-K3A5L1. I'm using a pass through cable and---AB DF1 DH485 driver in RSLinx. Am I on the wrong...
I am having pvc300 with me. I created my new program in ccw. The issue is that after clicking discover in ccw my hmi is not showing up there. Any...
merry christmas and happy new year
i have a click c0-00dr-d and allen bradley 2711c-t3m. can the panelview talk to the click plc via modbus...
Is this the clock battery flat?
Does anyone know how to remove the back of the PV 300 micro. Is it possible to replace this battery. AB says it's...
Hey Guys
I am trying to figure out the correct cable to use to connect from my laptop to this Panelview using panelbuilder32. I was sure I had...