antonidavel123
Member
Hi, Has any one got pinouts on a Mac 90 programming cable?
Mac 90 Prog. Cable
- Thread starter antonidavel123
- Start date
MartB
Lifetime Supporting Member
See if this helps at all, it's been years since I messed with one of these.
http://www.beijer.dk/MANUALS/MECOM/MECOM.pdf
http://www.beijer.dk/MANUALS/MECOM/MECOM.pdf
Similar Topics
Hi,
I have been trying to run drive via Sysmac studio. I can ping the drive. I can see the logic bits going on/off as per command. But, drive is...
Good morning to everyone on the forum and happy new year. I'm trying to use the following functions in sysmac studio, because I need to enable one...
So, here's probably a silly one that I hope someone here knows. I am working with a SYSMAC NA5 HMI. (First time doing anything with Omron.)
What...
Good morning everyone, I'm having difficulty using the "sin" and "cos" functions in sysmac, in particular the results of the functions are not...
looking for the the MAC address for this PLC, I count find it in the front or at any part of the PLC itself. connected to the PLC by USB, showing...