djf
Member
I have a question regarding input status checking. Any other suggestions welcome. We have a GE fanuc Series One with Hand Held Programmer. RUN mode led but no machine operation. Looking to confirm input status in program. The following observations have been made:
- Power Light is ON, Line & 24VDC power confirmed
- RUN light is ON, CPU light is OFF, Bat light is OFF
- Code can be viewed from Programmer
- Input Card LED's toggle with device toggle on both input cards
- Using MON, input status looks OK from the 16 Programmer LED's
- Outputs can be forced
- Viewing ladder and an Input address from the Programmer, toggling the input does not change status of the ON/OFF led.
Last item above, should I expect to see a status change at the ON/OFF led. Thanks!
- Power Light is ON, Line & 24VDC power confirmed
- RUN light is ON, CPU light is OFF, Bat light is OFF
- Code can be viewed from Programmer
- Input Card LED's toggle with device toggle on both input cards
- Using MON, input status looks OK from the 16 Programmer LED's
- Outputs can be forced
- Viewing ladder and an Input address from the Programmer, toggling the input does not change status of the ON/OFF led.
Last item above, should I expect to see a status change at the ON/OFF led. Thanks!