SLC5/05 and XBTGT5330

jedft

Member
J
Join Date
Jul 2004
Posts
145
I need a Telemecanique XBTGT5330 operator interface communicating over Ethernet to talk to an SLC5/05 on the same network. I was looking at the Prosoft Modbus communication modules, but I can't figure out which one I need to use. Anyone else done this?
 
The new Vijeo designer 4.4 software for the XBTG models supports Allen Bradley Ethernet/IP. If you can do that then you don't need a Prosoft module.


Steve
 
hmm... I think a big *DUH* is in order. Thanks! Does anyone know the best way to get egg off of one's face over Modbus/TCP?
 

Similar Topics

M
SLC5/03: (problem) Serial Communication RS232 to RS232 using Laptop DB9
I have wasted a week trying to figure out how to connect an SLC5/03 with my laptop. I do not have and can not Buy the 1747 UIC and PC3 cables. I...
Replies
14
Views
2,555
dmroeder
dmroeder
M
Beginner problem AB SLC5/03
I am trying to connect to SLC5/03 using an FTDI usb to rs232 with female to female converter at 1 end... however I can not connect to it ... the...
Replies
8
Views
1,270
Muhammad Abdullah
M
H
SLC5/03 to Panelview Plus 7 Standard
Good evening. I am in serious need of help. I am trying to connect a Panelview Plus 7 Standard to a SLC5/03(1741-L531) using a Moxa MGate...
Replies
3
Views
636
haldunkle
H
M
PLX51-net-eni comms between slc5/04 and panel view plus 7
Hi. I am having trouble establishing comms between an slc5/04 and panel view plus 7 via a PLX51-net-eni. The set up is: 5/04 Channel 0 DF1...
Replies
8
Views
922
Mikemator
M
A
SLC5/05 MSG Instructions
Hi All, I have programmed some MSG instruction in SLC5/05 64k CPU series D FW 13 brand new cpu. 2 of the MSG instructions are direct IP to other...
Replies
3
Views
980
OkiePC
OkiePC
Back
Top Bottom