Atlas Copco DS7-TENSOR & Versamax

Davev2005

Member
D
Join Date
Jul 2005
Location
San Luis Potosi
Posts
23
I need to program a DS7-TENSOR drive and Versamax PLC I look in the Atlas copco manual an says that I can use a line control, but I can't get any example.
I'll use discrete I/O for control this device.
If somebody can help me will be great.
 

Similar Topics

E
Atlas Copco DMC2-50720 using ECT software
It was hard trying to find the software ECT for this drive. Finally, I found it but since it is very old it is not intuitive at all. Is there a...
Replies
0
Views
106
elctronyc
E
B
Atlas Copco ToolsTalk software
Hi Guys, I'm looking for a download for the ToolsTalk software for atlas copco controllers (power focus). The laptop that had it died and of...
Replies
5
Views
3,163
BridieGreene
B
A
Old Software Atlas Copco Servo
Hi I´ve been looking around the web trying to find programming software for Atlas Copco DMC drive series..(Example: DMC 50720) This far I...
Replies
2
Views
2,503
elctronyc
E
G
Atlas Copco Wireless Torque Guns
Wizards, Has anyone used the wireless torque gun set up from Atlas Copco? I was asked to see if it would be an improvement to change over to...
Replies
2
Views
1,295
ValeoBill
V
S
Socapel / Atlas Copco / Danaher / Kollmorgan Software
I'm most likely out of luck here, but I'll give it a shot to ask... Does anyone have the following software? PAM Tools SAM Tools ProMotion...
2
Replies
20
Views
6,948
elctronyc
E
Back
Top Bottom