Atlas Copco DMC2-50720 using ECT software

elctronyc

Member
E
Join Date
Mar 2024
Location
new jersey
Posts
4
It was hard trying to find the software ECT for this drive. Finally, I found it but since it is very old it is not intuitive at all. Is there a way to save the program saved into the drive?
the only option I get is to download a new program but I know it will erased the one in the drive already. I am trying to see the commands in the terminal but non tell me about how to save that program.

thanks in advance for any replies
 

Similar Topics

B
Atlas Copco ToolsTalk software
Hi Guys, I'm looking for a download for the ToolsTalk software for atlas copco controllers (power focus). The laptop that had it died and of...
Replies
5
Views
3,168
BridieGreene
B
A
Old Software Atlas Copco Servo
Hi I´ve been looking around the web trying to find programming software for Atlas Copco DMC drive series..(Example: DMC 50720) This far I...
Replies
2
Views
2,506
elctronyc
E
G
Atlas Copco Wireless Torque Guns
Wizards, Has anyone used the wireless torque gun set up from Atlas Copco? I was asked to see if it would be an improvement to change over to...
Replies
2
Views
1,295
ValeoBill
V
S
Socapel / Atlas Copco / Danaher / Kollmorgan Software
I'm most likely out of luck here, but I'll give it a shot to ask... Does anyone have the following software? PAM Tools SAM Tools ProMotion...
2
Replies
20
Views
6,951
elctronyc
E
T
Software ECT for Atlas Copco DMC servo drive
Hello! I need the software ECT (for programming Atlas Copco DMC 50720 servo drives). Atlas Copco or Inmotion doesn't support this series anymore...
Replies
1
Views
1,531
elctronyc
E
Back
Top Bottom