logixpro elevator simulation

rakii

Member
R
Join Date
Feb 2010
Location
florida
Posts
3
having difficulty manipulating I:5 encoder & I:1/15 data for floor control? trying to use counters I:1/15 has a count of 0-124 not accurate to stop the floor in the correct position to allow the door to open? i have imported the I:5 encoder data to the acc of a counter though it sets the dn bit so i can't manipulate it? has any one finished this simulation?
 
Last edited:

Similar Topics

M
LogixPro Elevator simulation
this is my first post. Can i attach a plc file? I'm creating an elevator simulation in logixpro, and everytime I try to run it, the elevator...
2
Replies
26
Views
16,325
andreapg
A
S
LogixPro elevator simulation
Has anyone else had problems with labeling this exercise?? I add my documentation getting everything all nice and neat, save it, then close it...
Replies
5
Views
6,758
Ron Beaufort
Ron Beaufort
M
LogixPro Elevator Sim
Good morning. I am needing some direction on the elevator sim in Logixpro. I have the ladder written and functional but can't seem to get my stop...
Replies
1
Views
1,609
madoktor1
M
R
LogixPro elevator assistance needed
Hi everyone, I’m new to PLC programming, this is my first post. I finished TheLearningPit’s elevator exercise #4 a week ago and it worked. Wow...
Replies
8
Views
3,077
RWS8086
R
D
Logixpro Elevator Exercises:
Hi, I'm kind of new here. I am trying to do the Elevator problems but it's just not making sense to me. I am pretty bad at programming so it's...
Replies
6
Views
4,238
Lancie1
Lancie1
Back
Top Bottom