RedLion G308A2 to Animatics Motor Interface

I need to interface an Animatics "Smart" motor to a RedLion G308A2 HMI. After many tries along with help from tech support the consenses is that the driver in the new Crimson 3 does not work. I now need to write program using the "raw data" method. The examples from RedLion show only examples in Crimson 2 so I'm at a hard place to try and get the interface to work. Crimson 3 is so different then Crimson 2. I need to be able to read and write to a register in the Animatics motor to control a position destination. An example relating to the new Crimson 3 is needed.

Bit late for today, but I'll bring this up at our C3 status meeting tomorrow morning.

CHARDGEDCAP,

I am in the process of locating hardware to test the animatics driver. I will respond to your personal email with some info regarding this.
The technote I sent to you is for crimson 2.0, but the programming section works the same in crimson 3.0. I would rather see you use the built in driver, which will be more efficient and easier for you.

I will follow up with you via email
Thanks
Jeremy

Animatics "Smart" motor to a RedLion G308A2 HMI is the best according to me