Atlas Copco Temp & Pressure Sensors

recycled_mind

Member
R
Join Date
May 2007
Location
Cebu, Philippines
Posts
118
To Atlas Copco experts out there,

Does anyone here knows the complete specifications of the ff. temperature and pressure sensors installed in a GA 50 VSD compressor system?

PDT1 -Differential pressure sensor, oil separator
PT20 -Pressure sensor, air outlet
TT11 - Temperature sensor, compressor element outlet

I need the power supply and output specifications of these transmitters.


Thanks,
Alex
 

Similar Topics

E
Atlas Copco DMC2-50720 using ECT software
It was hard trying to find the software ECT for this drive. Finally, I found it but since it is very old it is not intuitive at all. Is there a...
Replies
0
Views
106
elctronyc
E
B
Atlas Copco ToolsTalk software
Hi Guys, I'm looking for a download for the ToolsTalk software for atlas copco controllers (power focus). The laptop that had it died and of...
Replies
5
Views
3,163
BridieGreene
B
A
Old Software Atlas Copco Servo
Hi I´ve been looking around the web trying to find programming software for Atlas Copco DMC drive series..(Example: DMC 50720) This far I...
Replies
2
Views
2,503
elctronyc
E
G
Atlas Copco Wireless Torque Guns
Wizards, Has anyone used the wireless torque gun set up from Atlas Copco? I was asked to see if it would be an improvement to change over to...
Replies
2
Views
1,295
ValeoBill
V
S
Socapel / Atlas Copco / Danaher / Kollmorgan Software
I'm most likely out of luck here, but I'll give it a shot to ask... Does anyone have the following software? PAM Tools SAM Tools ProMotion...
2
Replies
20
Views
6,948
elctronyc
E
Back
Top Bottom