Servo omron

vermaut

Member
V
Join Date
Oct 2010
Location
belgie
Posts
21
Hi

New with servo.
How can i convert the distance in pulses?
First i go to point A dan to point B

How can i convert it?

Regards

servo.jpg
 
Hello
Which Omron servo are you using?
We can probably put a gear-ratio in the drive so you can send 1000 pulses to the drive, and it can interpret these as 1000 mm (for example)

Paul
 

Similar Topics

S
Omron 1S Servo Motor Target Position Setting Out of Range
Hi All. I am setting up an Omron 1S Servo Motor to drive a conveyor. It goes forward 200mm, pauses and repeats until it is stopped. However...
Replies
3
Views
790
Peter Nachtwey
Peter Nachtwey
T
Uploading from Omron CJ2M EtherCAT servo system using CX-Programmer v9.7
I work for a used industrial machinery merchant. We try to get uploads from all our machines for future customer support and security. We have a...
Replies
0
Views
866
technolog
T
S
MELSEC MR-JE-40C Servo with Omron PLC
Hello, I am doing a positioning application for a paint spray machine. The horizontal indexing of the paint gun is done by a Tooth belt axis...
Replies
1
Views
1,698
parky
P
R
OMRON NC113 Module to HIWIN Servo Driver
Good day, I am having a problem with outputting pulse to the HIWIN servo driver using the OMRON NC113 module. The NC113 module is already...
Replies
10
Views
3,798
osmanmom
O
N
Omron Servo drive
Hi, I have some question relate with Omron servo drive I am using CJ1W-NC271 position control unit for servo drive In the CX-MOTION- NCF, I...
Replies
2
Views
1,655
naruto_yyc
N
Back
Top Bottom