Memory merker question.

DexterIt

Lifetime Supporting Member
D
Join Date
Oct 2010
Location
Italy
Posts
21
Hello dear guru's.
I am newcommer to PLC's programming,currently self teaching how to program the Siemens S-300 series using Step7 program,and because where i work we have all PLC's from Omron,i am forced to start learning the CX-programmer platform.All good until now,but here comes an easy question that i can not find a quick answer:When i want to map input into memory,in Step7 i use merkers like M0.0 , M0.1..... ans so on.How can i manage to do it in CX-programmer,because i cant find the instruction for this.
Thank you.
 

Similar Topics

P
WinCC RT Advanced - Data Logging Memory
Hi folks, I'm not as accustom with Siemens & WinCC, however I've been asked to increase the amount of data an existing application is logging...
Replies
2
Views
65
Plantationpark
P
M
Siemens S7-400 Memory Full
Hi, Yesterday, I was at a customer site. I made one little change. Changed a dummy bool output to an actual output. I didn't add any tags, or...
2
Replies
15
Views
328
Lare
L
J
Koyo memory location lookup in DL05
I have a c-more micro with a three digit input box on one of the screens. This is being written to a memory location in a DL05. I don't have the...
Replies
3
Views
109
jekndi
J
M
SLC 5/05 Not Retaining Memory After Power Cycle
Hello PLC friends. I've been going through a saga of diagnosing and fixing an old PLC setup that I inherited. I am learning as I go. Initial...
Replies
14
Views
335
Geoff White
G
S
Modicom BM85 Memory after Power Loss
Hi folks ! Got an older Modicom BM85 and I suspect that it's not passing data to ModBus+ network. We had a power loss for a few days and I suspect...
Replies
0
Views
68
Soundwave1974
S
Back
Top Bottom