Hello,
I need your help about Omron CPM1A.
I have two motors, two start and stop buttons.
M2 can run only if M1 is running and M2 cann be started 5 sec after M1 ( till full speed).
So far, so good.
But, problem for me is that M1 must be turn off (by PLC), 15 sec after I shutdown M2 only and not start him in mean time.
I know that this is probably not big deal, but I am newbie in this...
I work this in Syswin or CX Programmer.
I need your help about Omron CPM1A.
I have two motors, two start and stop buttons.
M2 can run only if M1 is running and M2 cann be started 5 sec after M1 ( till full speed).
So far, so good.
But, problem for me is that M1 must be turn off (by PLC), 15 sec after I shutdown M2 only and not start him in mean time.
I know that this is probably not big deal, but I am newbie in this...
I work this in Syswin or CX Programmer.