Reading wago incremental module
- Thread starter ssantiago
- Start date
if you use the PLC configuration then add your 637 you will see a complete list with all the in and outputs, if need more find www.oscat.de for routines.
and yes if wanted i can write them for you too.
and yes if wanted i can write them for you too.
Similar Topics
Hello
I have a s7-1200 and I would like to read the tags present in this controller with my controllogix controller. The two controllers don't use...
Hi all,
i have 8 CJ2m plc units that show different numbers on the plc display and i am stuck on reading the info.
my unit has an ip address of...
Hi Everyone,
I am not proficient in RSLogix 500 so I have a question regarding the evaluation of N7:0 data as an input.
So as I understand in...
Trying to setup a message read via Ethernet.
I have the path setup as 1, 1, 2, 192.168.66.10
I get an error code 1, ext err 315.
I am beating...
Dear all,
I don't know why setup of password became challenging and weird. After setting up the password and try to upload the ladder from the plc...