GE versamax micro

I'm getting this error can anybody help me

Validating Services
Target - TE_501
TE_501 - Logic Controller
Validating Hardware Configuration
Exporting folder...
Error 8036: Address '%R01002' on 'R01002[00]' is already used on 'R01001[1]'
Error 8036: Address '%R01003' on 'R01002[01]' is already used on 'R01001[2]'
Error 8036: Address '%R01004' on 'R01002[02]' is already used on 'R01001[3]'
Error 8036: Address '%R01005' on 'R01002[03]' is already used on 'R01001[4]'
Error 8036: Address '%R01006' on 'R01002[04]' is already used on 'R01001[5]'
Error 8036: Address '%R01007' on 'R01002[05]' is already used on 'R01001[6]'
Validating block: _MAIN....
Warning 8022: Type mismatch between variable and instruction.
Validating block: COMM....
Validating block: PARSE....
Warning 8022: Type mismatch between variable and instruction.
Validating block: CHAR7....
Validating block: CHAR11....
Validating block: CHAR6....
Validating block: CHAR20....
Validating block: BADDATA....
Validating block: MANUAL....
Warning 8022: Type mismatch between variable and instruction.

Validating Aborted - 6 error(s), 3 warning(s)

Tip: Press Shift+F3 to cycle through errors; F4 to cycle through errors and warnings.

You have defined two arrays with overlapping addresses. Somewhere in your logic there is an instruction that uses %R01001 through %R01006. Somewhere else there is an instruction that uses %R01002 through %R01007

You can either change the addresses referenced in the Errors or tell the system not to check for this error (Navigator Window > Options Tab > Controller > General, (Rt.Click > Properties)). Whichever is appropriate for your application.
If this is caused because you did not allow for 3 consecutive addresses for your timers and counters, fix that first.
To get more help on the error, be sure that the "Companion" window is visible (Window > Apply Theme > Logic Developer PLC > OK) and select the Error.
For help on the Timers and Counters select one in Ladder and press F!.

Or What Steve said.