Steve Bailey
Lifetime Supporting Member + Moderator
I Have a machine that the control part is a
Plc GE Fanuc Series one junior(Ic609sjr120c)
,and now i have problem with this plc,
because I don't have any manual & software programming
and cable to install this plc.So kindly ask you to help
me to install this plc .
I'm waiting for you reply Asap.
The manual is available on the GE Fanuc 'Legacy Products' CD. It is not available online. Publication number is GEK-90503. Your best bet for simple program changes is the handheld programmer. This is still available from Automation Direct as part number D3-HP. There was DOS-based software for the Series One Jumior. If you could still locate a copy, you would also need a Data Communications Unit.
My advice to you is to hire a local integrator with Series One (or TI305 or Simatic-TI or DL305) experience to get you through your current difficulties and have the same person quote a replacement that you will be able to maintain on your own.
Plc GE Fanuc Series one junior(Ic609sjr120c)
,and now i have problem with this plc,
because I don't have any manual & software programming
and cable to install this plc.So kindly ask you to help
me to install this plc .
I'm waiting for you reply Asap.
The manual is available on the GE Fanuc 'Legacy Products' CD. It is not available online. Publication number is GEK-90503. Your best bet for simple program changes is the handheld programmer. This is still available from Automation Direct as part number D3-HP. There was DOS-based software for the Series One Jumior. If you could still locate a copy, you would also need a Data Communications Unit.
My advice to you is to hire a local integrator with Series One (or TI305 or Simatic-TI or DL305) experience to get you through your current difficulties and have the same person quote a replacement that you will be able to maintain on your own.
