MasterBlaster
Lifetime Supporting Member
I have need for a low-amperage (less than one amp @120vac) dry contact in a timer that I can set to be closed (on) for xxx seconds and then open (off) for xxx seconds.
I can provide an external source of power, no problem.
Once I determine the two times (approximately three minutes in each 'state', changing the settings will be infrequent (and therefore need not be convenient).
Thanks in advance for any suggestions?
Bill
I can provide an external source of power, no problem.
Once I determine the two times (approximately three minutes in each 'state', changing the settings will be infrequent (and therefore need not be convenient).
Thanks in advance for any suggestions?
Bill