valter.carvalho
Member
Hello everyone,
I'm placing a Powerlogic meter (PM800) to read a Sepam S80 relay information and send it to my Controllogix.
The meter is communicating via a Prosoft Ethernet Modbus card. I already have the description of the words I want to configure.
However, once I enter these words in the Prosoft configurator app (Prosoft Configurator Builder), I will need a block to get these words from the MNet card and place them in readable words on the Controllogix.
My question is: Someone has a block that already does that, ie, take the words from the Prosoft card (using an offset for example) and place them in correct tags (ie: Apparent Voltage, Voltage A-B. Current A, etc)?
Thanks in advance,
Valter
I'm placing a Powerlogic meter (PM800) to read a Sepam S80 relay information and send it to my Controllogix.
The meter is communicating via a Prosoft Ethernet Modbus card. I already have the description of the words I want to configure.
However, once I enter these words in the Prosoft configurator app (Prosoft Configurator Builder), I will need a block to get these words from the MNet card and place them in readable words on the Controllogix.
My question is: Someone has a block that already does that, ie, take the words from the Prosoft card (using an offset for example) and place them in correct tags (ie: Apparent Voltage, Voltage A-B. Current A, etc)?
Thanks in advance,
Valter