505 worshop

rajapadha

Member
R
Join Date
Dec 2012
Location
Singapore
Posts
1
Folks, I am new to 505workshop/TIsoft programming. Need to input a data for an Analog output address (WY) . may I know how to go about and suggest me the procedure whether to do it online and offline.Tks

Regards,
rajapadha
 
I would probably use a Special Function Program to run the output. If you simply want to put data on the output then you would just create a "math" line that says "your data" := wyXXX
 

Similar Topics

M
SLC 505 Outputs not firing
Hello all. I have a few SLCs in my plant and of late we've seen a weird issue: The system will be running normally and then randomly the outputs...
Replies
2
Views
95
Mark_J
M
F
Compare TISoft Siemens Simatic TI505 ladder logic
Hi. I have 2 files where I would like to see the ladder logic differences (similar to the Rockwell compare function). I am using TISoft Siemens...
Replies
1
Views
1,264
Henny
H
D
BootP for SLC505
Hello. I'm using bootp to set an ip address for a 1747L551 processor. The bootp program immediately sees the mac id and I am able to enter an...
Replies
5
Views
1,180
DairyBoy
D
R
ControlLogix SLC Typed Read/Write SLC 505
Hello, I inherited a control system one of my predecessors thought it was a good idea to put logic for cant optimization and Kinetix motion...
2
Replies
15
Views
3,554
ruairicussen
R
A
slc 502, 503, 504, 505's
Probably a silly question and asked a hundred times already, but i tried to do some searching here and couldn't find this question. I have 502's...
Replies
9
Views
3,000
padees
P
Back
Top Bottom