SLC100 Instruction Help

I’m replacing an old SLC100 system with a Micrologix system and since the SLC100 is before my time and I can’t find any documentation on AB’s site I was wondering if someone can help me with a few instructions.

1. What’s the time base on the RTO? .1?

2. What’s the time base on the RTF? .01?

3. Does the RTO accumulated value reset back to 0 when the rung goes false, or do you have to use RST to reset the accumulated value back to 0? The reason I as is because I have noticed that on one rung there is If 701 then RTO, then on the next rung there is If Not 701 then RST.

4. SQO Table - Well, I can't get it to format correctly, but it's close, in the Hex Mask, the 0 is under 706 and the 3 is under 703.
-------------------------------------------------------
: Time Driven : :
:I/O Address: 708 707 706 705 704 703 702 701 : 901 :
:Hex Mask : 0 3 :-(SQO)-:
:Binary Mask: 0 0 0 0 0 0 0 0 :GRP 16 :
-------------------------------------------------------
: Step : Hex: Binary : Preset:
: # ata: Data : Value :
-------------------------------------------------------
: 00 : 01 : - - - - - - 0 1 : 0020 :
: 01 : 02 : - - - - - - 1 0 : 0010 :
-------------------------------------------------------
It appears to me that 701 and 702 are flipping every second, is this correct?


Thanks for the help,
Pat

You're in luck! You can download the SLC 100/150 User Manual HERE...

That should answer these questions, and many more!...

beerchug

-Eric