CPU 315-2dp 6ES7 315-2AG10-0AB0
Module:
CP 340-RS232C 6ES7 340-1AH02-0AE0
When I'm using I/O module I'm sending data from DB's to printer ZebraGX430t. Everything was fine, protocols and hardware settings were properly configured, printer was working how it should, data stream was ok... but it was only for a few hours.
Printer stopped working, i checked configuration and prgoram but there weren't any changes. After Cpu reset, printer come back to living annd i coudn't see any problem, but next day situation appeard.
I managed to printscreen errors from module, but i don't know the issue. Aflso added P_Reset block to clean buffer but i'm not sure if it'll help.
Thanks for any ideas.
Errors:
http://postimg.org/image/81qotkbxj/
http://postimg.org/image/3tvwktahz/
Module:
CP 340-RS232C 6ES7 340-1AH02-0AE0
When I'm using I/O module I'm sending data from DB's to printer ZebraGX430t. Everything was fine, protocols and hardware settings were properly configured, printer was working how it should, data stream was ok... but it was only for a few hours.
Printer stopped working, i checked configuration and prgoram but there weren't any changes. After Cpu reset, printer come back to living annd i coudn't see any problem, but next day situation appeard.
I managed to printscreen errors from module, but i don't know the issue. Aflso added P_Reset block to clean buffer but i'm not sure if it'll help.
Thanks for any ideas.
Errors:
http://postimg.org/image/81qotkbxj/
http://postimg.org/image/3tvwktahz/