Jeroen Benoot
Member
Hi guys,
I am having some trouble at the moment setting up a serial connection between a Datalogic Powerscan D8330 barcodescanner and a Siemens S7 315 CPU with a CP340 card.
PLC configuration is a 315 with two CP340 cards, one I use for the barcodescanner, and the other I will use for connection with a PC.
I have set the correct baud rate etc in the hardwareconfig.
Even when I connect the scanner to my PC and use software to scan the Com-port I get nothing.
Any ideas where to begin?
Best regards,
Jeroen
I am having some trouble at the moment setting up a serial connection between a Datalogic Powerscan D8330 barcodescanner and a Siemens S7 315 CPU with a CP340 card.
PLC configuration is a 315 with two CP340 cards, one I use for the barcodescanner, and the other I will use for connection with a PC.
I have set the correct baud rate etc in the hardwareconfig.
Even when I connect the scanner to my PC and use software to scan the Com-port I get nothing.
Any ideas where to begin?
Best regards,
Jeroen