OLI CHARVILL
Member
hi all,
I am new to this page but work in the automotive trade as electrical mechanical maintenance engineer just done a basic plc course with Siemens through work,
the problem I have is that a 314 ifm plc which is used to control a 250tonne heating press but the 1st and 2nd built in rack on the plc is getting extreamly hot there is also 5 expansion racks,
I don't know if this is common I have checked other presses at work but plcs seem to be at normal temp,
also to load and configure an new plc same model, with the same plc program and wincc program for hmi screen, I am write in saying I need the original programs on my pg inorder to configure the new one??
Many Thanks For Any answers Oli
I am new to this page but work in the automotive trade as electrical mechanical maintenance engineer just done a basic plc course with Siemens through work,
the problem I have is that a 314 ifm plc which is used to control a 250tonne heating press but the 1st and 2nd built in rack on the plc is getting extreamly hot there is also 5 expansion racks,
I don't know if this is common I have checked other presses at work but plcs seem to be at normal temp,
also to load and configure an new plc same model, with the same plc program and wincc program for hmi screen, I am write in saying I need the original programs on my pg inorder to configure the new one??
Many Thanks For Any answers Oli