- Interactive Q & A - Interactive Q & A (
-   LIVE PLC Questions And Answers (
-   -   1734-AENT Module Status solid red (

Kataeb October 25th, 2017 05:15 AM

1734-AENT Module Status solid red
Kindly, we have the following module with its Module Status led solid red.
What can we do to solve this?
" POINT I/O EtherNet/IP Adapter Module , 1734-AENT , Rockwell , series A revision 2 "

In the manuals it is mentioned the following probable cause.
If we download its firmware again will it help?
" Firmware fatal error present. [Unrecoverable fault has occurred: Self-test failure present (checksum failure, or RAMtest failure at cycle power).] "

seth350 October 25th, 2017 06:32 AM

You can try, it’s already broke. Can’t break it anymore.

Kataeb November 24th, 2017 03:57 AM

1 Attachment(s)
we downloaded the firmware, but got below errors. see also attached. what do they mean? thank you

[FAILURE] Device Identity: Error #11002: Unknown Extended Status error code received.
GS=0x01, ES=0x0312
[-------] Device Identity: Error #10005: GetAttributesSingle to Device object - target does not support hardware revision.
Error #11009: Attribute Id not supported.
[FAILURE] Reset: Error #11003: Unconnected Send timed out waiting for a response.
GS=0x01, ES=0x0204

daba November 24th, 2017 05:04 AM

As already stated, the module is "broken", as indicated bu the solid red module status LED....

Replace it and don't waste any more time.

Karim Halawa May 3rd, 2018 09:13 AM

can you please advise the required status for 1734-AENT replacement procedures

Kataeb May 3rd, 2018 09:27 AM

Recommended procedure:
How to replace a 1734-AENT Point I/O EtherNet Adapter?
1. Set the IP Address on the replacement 1734-AENT using the Thumbwheel or BOOTP-DHCP Server..
2. Set the Chassis Size on the replacement 1734-AENT.
You can use the 1734-AENT Web Pages to set the Chassis Size.

pal May 3rd, 2018 01:48 PM

Once you have set the IP address , you can also set the chassis size from RS Linx.

All times are GMT -5. The time now is 06:33 AM.