LTBarnette
Member
Hello everyone.
Found this board and got some great Ideas on here so I thought I would ask my question, which I have seen in some parts all over this board. When I installed the 1747-SDNPT driver on RsLinx I chose the card 1747-SDN and went thought the setup. I said it was adding it and found it on the proper slot in the SLC 5/05. However when I go back in to look at the card in RsLinx it does not show it under the new driver 1747-SDNPT-1. It keeps browsing and also it is not the SLC 5/05 driver. I have RsLinx version 2.20 and the scanner card has 4.015 firmware on it. I did go into the SLC 5/05 through my Ethernet connection and changed the m1 and m2 to 361 before I tried anything on Rslinx. I have the firmware upgrade to 6 for the scanner, but it cannot find it to install. Were would be a good place for me to start? I have latest version of RsNetworx also but was told it will not see the 1747-SDN because the firmware 4.015 will not work it has to be flashed to 6.
Thanks,
Todd
Found this board and got some great Ideas on here so I thought I would ask my question, which I have seen in some parts all over this board. When I installed the 1747-SDNPT driver on RsLinx I chose the card 1747-SDN and went thought the setup. I said it was adding it and found it on the proper slot in the SLC 5/05. However when I go back in to look at the card in RsLinx it does not show it under the new driver 1747-SDNPT-1. It keeps browsing and also it is not the SLC 5/05 driver. I have RsLinx version 2.20 and the scanner card has 4.015 firmware on it. I did go into the SLC 5/05 through my Ethernet connection and changed the m1 and m2 to 361 before I tried anything on Rslinx. I have the firmware upgrade to 6 for the scanner, but it cannot find it to install. Were would be a good place for me to start? I have latest version of RsNetworx also but was told it will not see the 1747-SDN because the firmware 4.015 will not work it has to be flashed to 6.
Thanks,
Todd