We have an intellution system looking at an slc through data highway rio card on a control logix chasis. The control logix chasis also has an ethernet module. This system was working at one time but is currently down. I am not fimiliar with the abr driver or power tool software. I have a driver configured in linx as follows:
Name: TCP-2
Server's IP 192.168.6.x
Remote Driver AB_ETH-4
Name: AB_ETH-4
Type: Ethernet Devices
CLX IP: 10.249.12.xx ENET module is a 1756-ENBT/A
Slot 6 is where the 1756-DHRIO/B module resides in the CLX chasis
The SLC is on Channel A Node 02
The abr configuration is as follows:
Channel Name: Channel0
Enable: Yes
Channel Setup: Device First
Primary Ethernet Gateway Channel Setup:
Rslinx Driver: TCP-2
Backup: None
Reply Timeout: 01
Retries: 3
Delay Time: 10
Device Name: SLC1
Enable: Yes
Device Setup:
PLC Type: SLC 500
Routing Setup:
Primary: 1756-GTWY
Device Primary Channel Setup:
Primary DH+ Addr: 2
Backup DH+ Addr: None
Gateway Path: Ethernet->DH+
Destination Link ID: 0
Slot: 6
Channel: 2 We changed this it was 1 but neither made it work.
We have stopped the driver channel and datablock and nothing changes. We have restarted linx and the pc running intellution and linx. We were first getting overruns and no transmits or recieves now we are getting overruns and transmitts but no recieves and the data status is showing bad,comm failure.
Any help or a point in a direction to help files for the ABR or powertools software would be greatly appreciated. I am at a standstill. I know the plc hardware is good because I can see it through rsview studio se application. This uses just the topic I configured in linx that points directly at the slc going through the i/o tree of the contrologix.
Thanks,
Corey
Name: TCP-2
Server's IP 192.168.6.x
Remote Driver AB_ETH-4
Name: AB_ETH-4
Type: Ethernet Devices
CLX IP: 10.249.12.xx ENET module is a 1756-ENBT/A
Slot 6 is where the 1756-DHRIO/B module resides in the CLX chasis
The SLC is on Channel A Node 02
The abr configuration is as follows:
Channel Name: Channel0
Enable: Yes
Channel Setup: Device First
Primary Ethernet Gateway Channel Setup:
Rslinx Driver: TCP-2
Backup: None
Reply Timeout: 01
Retries: 3
Delay Time: 10
Device Name: SLC1
Enable: Yes
Device Setup:
PLC Type: SLC 500
Routing Setup:
Primary: 1756-GTWY
Device Primary Channel Setup:
Primary DH+ Addr: 2
Backup DH+ Addr: None
Gateway Path: Ethernet->DH+
Destination Link ID: 0
Slot: 6
Channel: 2 We changed this it was 1 but neither made it work.
We have stopped the driver channel and datablock and nothing changes. We have restarted linx and the pc running intellution and linx. We were first getting overruns and no transmits or recieves now we are getting overruns and transmitts but no recieves and the data status is showing bad,comm failure.
Any help or a point in a direction to help files for the ABR or powertools software would be greatly appreciated. I am at a standstill. I know the plc hardware is good because I can see it through rsview studio se application. This uses just the topic I configured in linx that points directly at the slc going through the i/o tree of the contrologix.
Thanks,
Corey