I have a Micro830 PLC and have the software installed. Because I have not had any luck so far, I have reduced the logic to 1 rung with an _IO_EM_DI_00 input and a _IO_EM_DO_00 output.
I picked these right off the dropdown list.
I have used visual basic for a long time and the programming environment seems a bit similar.
I build the project download and debug... the software is talking to the PLC because it shows as being connected and asks about the remote run switch etc.
When try to debug and I touch the voltage to the input, the indicator on the PLC lights up, but I see no indication on the ladder logic that the input has changed and the output does not change.
What am I doing wrong?
I picked these right off the dropdown list.
I have used visual basic for a long time and the programming environment seems a bit similar.
I build the project download and debug... the software is talking to the PLC because it shows as being connected and asks about the remote run switch etc.
When try to debug and I touch the voltage to the input, the indicator on the PLC lights up, but I see no indication on the ladder logic that the input has changed and the output does not change.
What am I doing wrong?