jacoffey85
Member
Here's the scenario, We have a ControlLogix processor with three 1756-EN2TR modules:
Referring from the picture:
[2] - 1756-EN2TR - IP is 10.64.89.XXX - Communicates with the main line
[3] - 1756-EN2TR - IP is 10.64.90.XXX - Communicates with the main customer server
[4] - 1756-EN2TR - IP is 10.64.96.XXX - Internal machine network (contains our point I/O and drives).
The customer is wanting to be able to connect to our PLC through the main line card, and be able to still see all of our point I/O and drives from the master control station for troubleshooting purposes.
Whenever RSLinx is opened, they are able to see the EN2TR (machine network) but cannot see the Stratix switch directly after it or anything connected to the drives. Obviously when I plug into the machine network I can see the Stratix and everything connected to it.
Is there some kind of port inside of the EN2TR that I need to open or could it be an issue with the Stratix configuration? We have a major shutdown next week so I'm hoping I can have a solution for them during that time.
Also I did try to do some searching, but I might not have had the right terminology, as I couldn't find anything that really helped.
Thanks in advance!
Referring from the picture:
[2] - 1756-EN2TR - IP is 10.64.89.XXX - Communicates with the main line
[3] - 1756-EN2TR - IP is 10.64.90.XXX - Communicates with the main customer server
[4] - 1756-EN2TR - IP is 10.64.96.XXX - Internal machine network (contains our point I/O and drives).
The customer is wanting to be able to connect to our PLC through the main line card, and be able to still see all of our point I/O and drives from the master control station for troubleshooting purposes.
Whenever RSLinx is opened, they are able to see the EN2TR (machine network) but cannot see the Stratix switch directly after it or anything connected to the drives. Obviously when I plug into the machine network I can see the Stratix and everything connected to it.
Is there some kind of port inside of the EN2TR that I need to open or could it be an issue with the Stratix configuration? We have a major shutdown next week so I'm hoping I can have a solution for them during that time.
Also I did try to do some searching, but I might not have had the right terminology, as I couldn't find anything that really helped.
Thanks in advance!