Hi,
My question is about the digital input on the Kinetix 5500.
Is there a way to trigger a repetitive precise movement by using a proximity sensor.
In my context, I'm using a servo that moves 350 increments per minute and I don't want to lose time because of the latency of the ethernet communication and the proccessing.
I know that I can wire my sensor through an input of my PLC, process it and output it to my drive after that. But is there a way to do it witout passing in the PLC
The servo does the same incremental movement again and again. (no complex positionning)
I consider myself as beginner in PLC programming.
Thanks in advance
JG
My question is about the digital input on the Kinetix 5500.
Is there a way to trigger a repetitive precise movement by using a proximity sensor.
In my context, I'm using a servo that moves 350 increments per minute and I don't want to lose time because of the latency of the ethernet communication and the proccessing.
I know that I can wire my sensor through an input of my PLC, process it and output it to my drive after that. But is there a way to do it witout passing in the PLC
The servo does the same incremental movement again and again. (no complex positionning)
I consider myself as beginner in PLC programming.
Thanks in advance
JG