Hi:
I have a CompactLogix L33ER (Rev 28) with a 1769-SDN Scanner (Rev 4). I have my network working OK. I can start, stop and read AMPS from all motors. The problem is when I need to change a parameter to an E3 Plus via RSNetworx. When I go online I only see the scanner (node 0), all the other nodes show disconnected with the red sign. In RSLinx is the same problem, can't browse the DeviceNet network from my laptop (EtherNet/IP).
I repeat that the network is working because in FTView I see all motors and I can read current, status, etc and can start and stop motors. The problem is that I need to add mores nodes to the network and change parameters to others.
This problem began when I replaced the old CPU (L35E) with this new one.
Any suggest?
Thanks!
I have a CompactLogix L33ER (Rev 28) with a 1769-SDN Scanner (Rev 4). I have my network working OK. I can start, stop and read AMPS from all motors. The problem is when I need to change a parameter to an E3 Plus via RSNetworx. When I go online I only see the scanner (node 0), all the other nodes show disconnected with the red sign. In RSLinx is the same problem, can't browse the DeviceNet network from my laptop (EtherNet/IP).
I repeat that the network is working because in FTView I see all motors and I can read current, status, etc and can start and stop motors. The problem is that I need to add mores nodes to the network and change parameters to others.
This problem began when I replaced the old CPU (L35E) with this new one.
Any suggest?
Thanks!