I am struggling with getting this thing started.
I have installed Crimson 3.0 to a laptop and have connected a USB to RS232 converter that works perfectly with another device.
I think I need confirmation of pinouts to make a cable that will go from the converter to the HMI.
The existing device used the following pins:
Converter Pin1 >> Jump to Converter Pin4
Converter Pin2 >> Device Pin 3
Converter Pin3 >> Device Pin 2
Converter Pin4 >> Jump to Converter Pin 1 & Converter Pin 6
Converter Pin5 >> Device Pin 5
Converter Pin6 >> Jump to Converter Pin 4
Converter Pin7 >> Jump to Converter Pin 8
Converter Pin8 >> Jump to Converter Pin 7 and Device Pin 8
Converter Pin9 >> No Connection
I also need some guidance as to which port I should use.
Thanks,
rmb
I have installed Crimson 3.0 to a laptop and have connected a USB to RS232 converter that works perfectly with another device.
I think I need confirmation of pinouts to make a cable that will go from the converter to the HMI.
The existing device used the following pins:
Converter Pin1 >> Jump to Converter Pin4
Converter Pin2 >> Device Pin 3
Converter Pin3 >> Device Pin 2
Converter Pin4 >> Jump to Converter Pin 1 & Converter Pin 6
Converter Pin5 >> Device Pin 5
Converter Pin6 >> Jump to Converter Pin 4
Converter Pin7 >> Jump to Converter Pin 8
Converter Pin8 >> Jump to Converter Pin 7 and Device Pin 8
Converter Pin9 >> No Connection
I also need some guidance as to which port I should use.
Thanks,
rmb