Hello all,
I’ve run into an issue when replacing an existing PanelView 900 (2711-T9C8) with a new one. The PV is networked to a SLC 05/04 using DH+. When I power the new PV up into configuration mode and go to the communication settings it says “No active nodes found on network”. I’ve set the the new PV to the same settings as the old one,
Node : 2
Baud : 230.4k
The new PV900 is the same part number as the old one and I was able to load the program from the card without any problem. The only difference I can see between the two are the Boot and Firmware versions are not the same.
Old PV
Boot : V01.06
Firmware : V04.20
New PV
Boot : V01.05
Firmware : V04.41
Could this be causing the communication issue I’m having? I apologize in advance if this is a basic question, I’m not very experienced with Panelviews.
Edit: I forgot to mention that reinstalling the old PV it is able to communicate with the processor.
I’ve run into an issue when replacing an existing PanelView 900 (2711-T9C8) with a new one. The PV is networked to a SLC 05/04 using DH+. When I power the new PV up into configuration mode and go to the communication settings it says “No active nodes found on network”. I’ve set the the new PV to the same settings as the old one,
Node : 2
Baud : 230.4k
The new PV900 is the same part number as the old one and I was able to load the program from the card without any problem. The only difference I can see between the two are the Boot and Firmware versions are not the same.
Old PV
Boot : V01.06
Firmware : V04.20
New PV
Boot : V01.05
Firmware : V04.41
Could this be causing the communication issue I’m having? I apologize in advance if this is a basic question, I’m not very experienced with Panelviews.
Edit: I forgot to mention that reinstalling the old PV it is able to communicate with the processor.
Last edited: