Rutesh M Deshmukh
Member
Hello frnds....
i configured channel 0(8-pin port) of my Micrologix 1400 PLC to DH485 & download Program in PLC using Ethernet.
& now i want to communicate my PLC to PC through NET- AIC using same channel i.e channel 0(8-pin).
is it possible???????
reply for suggestions....
Thanks and regards
Rutesh deshmukh
i configured channel 0(8-pin port) of my Micrologix 1400 PLC to DH485 & download Program in PLC using Ethernet.
& now i want to communicate my PLC to PC through NET- AIC using same channel i.e channel 0(8-pin).
is it possible???????
reply for suggestions....
Thanks and regards
Rutesh deshmukh