Chris K
Member
Hello,
I am trying to build a test station for servos using Kinetix 6500, All is well, except when I am trying to run Motion Direct command, beside MAH, MSO, MSF I am getting error "execute on an axis whose servo loop is not closed". What can cause that? It's wiring problem or should I look in the code? Any tips will be greatly appreciate.
I am trying to build a test station for servos using Kinetix 6500, All is well, except when I am trying to run Motion Direct command, beside MAH, MSO, MSF I am getting error "execute on an axis whose servo loop is not closed". What can cause that? It's wiring problem or should I look in the code? Any tips will be greatly appreciate.