Ones_Zeros
Member
Hey Guys
I have several scripts to write in Wonderware & I was concerned about the limit of lines in a script. I have been placing them
under in the Data Change Script by using the variable $Minute.
This is a built in variable within Wonderware that runs the script each minute.
My question is this, I know there must be a limit on the number of lines that a script can be.
Is there a better variable to use or how could I configure these scripts to run each minute without using the $Minute variable?
thanks,
I have several scripts to write in Wonderware & I was concerned about the limit of lines in a script. I have been placing them
under in the Data Change Script by using the variable $Minute.
This is a built in variable within Wonderware that runs the script each minute.
My question is this, I know there must be a limit on the number of lines that a script can be.
Is there a better variable to use or how could I configure these scripts to run each minute without using the $Minute variable?
thanks,