Tony.Morgan
Member
Today I modified a couple of networks of an existing program offline using Medoc Plus saving as a new filename. On attempting to transfer the modified program via the HMI(transparent mode) to the PLC I was greeted with the message 'PLC Comms Failed or PLC wrong type'. I then tried direct to CPU via SC-09 lead still getting same message.
I went on to try and transfer/monitor the existing program rev. again with no luck.
Modifying and transferring programs is something I do regularily but have never had this problem. It may be a coincidence but I installed some datalogger software on my laptop prior to carrying out the above.
Any pointers before I call Mitsubishi???
I went on to try and transfer/monitor the existing program rev. again with no luck.
Modifying and transferring programs is something I do regularily but have never had this problem. It may be a coincidence but I installed some datalogger software on my laptop prior to carrying out the above.
Any pointers before I call Mitsubishi???