einnh
Lifetime Supporting Member
Just got off the phone with tech connect about this issue, they had a few things for me to try but admitted the error message wasn't clear enough for them to figure out?
I have a machine here that had been running for about a year that required some logic updates today. Decided to update the firmware at the same time.
Firmware updated fine to v33 (was v31)...
Went to download the logic, which 'builds' and 'verifies' fine, and after all the routines download I am presented with:
Error: Invalid attribute value.
I have seen similar errors before but they would always tell me which module and what the issue was. This one has no link and doesn't say where the problem is.
Any ideas on how to trouble shoot this one?
I have a machine here that had been running for about a year that required some logic updates today. Decided to update the firmware at the same time.
Firmware updated fine to v33 (was v31)...
Went to download the logic, which 'builds' and 'verifies' fine, and after all the routines download I am presented with:
Code:
...
Downloading routine 'torque_control'
Downloading routine 'vfd_contactor'
Creating all alarm sets...
Downloading all alarm conditions...
Downloading all alarm sets...
Downloading all Modules...
Error: Invalid attribute value.
Error: Download operation still in progress.
Error: Failed to download modules.
Cancelling download...
Complete - 3 error(s), 0 warning(s)
I have seen similar errors before but they would always tell me which module and what the issue was. This one has no link and doesn't say where the problem is.
Any ideas on how to trouble shoot this one?